Manufacturer's Warranty - Tools; Disposal; Trouble Shooting - Hilti TE SX Mode D'emploi

Manufacturer's warranty – tools
Please contact your local Hilti representative if you have
questions about the warranty conditions.

Trouble shooting

Symptom
The tool doesn't start
No hammering action
The tool does not produce
full power
(Switch for automatic function
in OFF position)
The tool does not switch to faster
speed after the given time
(approx. 5 sec.)
(Switch for automatic function
in ON position)
The drill bit cannot be released
from the chuck
Printed: 06.11.2015 | Doc-Nr: PUB / 5136127 / 000 / 01

Disposal

they can be recycled. In many countries, Hilti has already
made arrangements for taking back your old electric tools
for recycling. Please ask your Hilti customer service
department or Hilti sales representative for further infor-
mation.
Disposal of electric tools together with household waste
is not permissible!
In observance of European Directive on waste electrical
and electronic equipment and its implementation in
accordance with national law, electric tools that have
reached the end of their life must be collected separately
and returned to an environmentally compatible recycling
facility.
Possible cause
Fault in the electric power supply
Defective supply cord or plug
Switch defective
The tool is too cold
Cross-section of the extension
cable is inadequate
Switch for automatic function is
defective
The chuck locking sleeve is not
turned fully towards the
( ) symbol (fig. )
Most of the materials from which Hilti power
tools are manufactured can be recycled. The
materials must be correctly separated before
Only for EU countries
Possible solution
Plug in another electric tool and check
whether it starts
Have it checked by an electrical
specialist and replace if necessary
Have it checked by an electrical
specialist and replace if necessary
Allow tool to reach the minimum
operating temperature
(see section "Preparation for use")
Use an extension cable of adequate
cross-section
(see section "Before use")
Move switch for automatic function to
OFF position and have the electronic
switch immediately replaced
Turn the chuck locking sleeve fully
towards the ( ) symbol (fig. )
15