Baier BSS 506 Mode D'emploi page 12

Note: The automatic filter dedusting func-
tion can only be switched on/ off when the
appliance is switched on.
To switch off automatic filter cleaning:
–
 Activate the switch. Indicator lamp in
the switch goes off.
To switch on automatic filter cleaning:
–
 Press the switch again. Indicator lamp
in the switch glows green.
Insert with paper filter bag
Paper filter bags are not suitable for use
with electric tools.
Installation of paper filter bag (only for
cleaning procedures)
 Release and remove the suction head.
 Insert the paper filter bag or the mem-
brane filter (special attachment).
 Insert and lock the suction head.
Wet vacuum cleaning
Inserting the rubber lips
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
12
1.
2.
Remove the paper filter bag
To suck wet dirt, first remove the paper
–
filter bag.
It is recommended to use a flat folded
–
filter (PES) (wet) (ID no. 73684).
General
Caution
The flat pleated filter must must always be
in place while vacuuming.
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Turn off the appliance
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
– 3
EN