Initial Operation - Orderman 2 Mode D'emploi

operating instructions
Routine care:
ALWAYS disconnect Base Station2 from the charger or the mains
before cleaning!
Caution
Cleaning notes:
Tip
Use a soft c loth moistened w ith a w eak solution o f a m ild det ergent and
water to clean Base Station2's exterior.
Do not use compressed air to clean Base Station2 or its components.
Before installing Base Station2 turn the included antenna clockwise until it
is stopped by the screw extension. This can be done manually.
Base Station2 is intended for setup indoors. It can be installed in a s tand-
ing position or wall- or ceiling-mounted (upside down).
For optimum performance avoid installing Base Station2 near m etallic ob-
jects.
The status display is controlled by means of the Oman.exe program.
For w all-mounting or at taching an ex pansion module ( option), r emove
Base Station2's antenna by rotating it counter-clockwise. Then remove the
screw by t urning i t c ounter-clockwise ( can be do ne m anually) and l ift t he
plastic c over and t he illuminated r ing ( status di splay) from the hous ing.
The base pl ate has two hol es f or wall-mounting. Installation of the expan-
sion module is described in its operating instructions manual.
Additional i nformation on i nitial oper ation c an be f ound i n t he i nstallation
instructions for the Orderman system.

Initial operation

6
Base Station2