Delta 22-790X Manuel D'utilisation page 13

ADJUSTING THE ROLLER EXTENSION TABLES
The roller tables must be set according to these instructions
to avoid snipe. Follow instructions below for both infeed
and outfeed tables.
1. Loosen three bolts (HH) Fig. 25. Loosen just enough
so table can be moved up or down to make the
adjustments described below.
2. Place a short straight edge (II) Fig. 26 flat on one side
of the platen (JJ) and touching the inside roller (KK).
3. Adjust the table so that the straight edge will rest
evenly on the platen (JJ) Fig. 26 and the top of the
inside roller (KK). Tighten the bolt (HH) that is directly
below the straight edge.
4. Move straight edge (II) to the other side of platen and
adjust table so the straight edge will rest evenly on
the platen and the top of this side of the inside roller.
Tighten the bolt (HH) that is directly below the straight
edge on that side of the table. Then tighten the middle
bolt. Now all three bolts should be tight and the inside
roller should be level with the platen.
5. Place two dimes (LL) Fig. 27 in line with each other,
one at each end of one side of the platen as shown.
6. Place a long straight edge (one shown in Fig. 28 is 48"
(122 cm)) on both dimes (LL) and extend it out until it
also touches the outer roller (MM) Fig. 28.
7. Loosen screws (NN) (one shown at Fig. 29) on both
sides of roller table. loosen just enough so the end of
the roller table can lifted up or pushed down to make
the adjustment described below.
8. Adjust table (by lifting or lowering the outer roller) so
that the straight edge will rest evenly on the dimes
(one is shown at (LL) Fig. 28) and the top of the outer
roller (MM) Fig. 27. Tighten the screw (NN) that is on
the same side of table as straight edge.
9. Move straight edge and dimes to the other side of the
platen and roller table and repeat STEP 8.
10. Re-check the inside roller for proper alignment as
described in STEP 3. Repeat STEP 3 if needed.
11. Re-check the outer roller for proper alignment as
described in STEP 8. Repeat STEP 8 if needed.
12. Repeat process for other table.
MM
LL
NN
Fig. 28
13
HH
II
KK
LL
Fig. 25
JJ
Fig. 26
Fig. 27
Fig. 29