Delta 22-790X Manuel D'utilisation page 11

HOW TO ATTACH THE PLANER TO THE STAND
1. CAREFULLY lift the planer on the stand.
2. Align the four holes in the bottom of the planer (not
shown) with the mounting holes (AA) Fig. 16 in the top
of the stand.
3. Use the four remaining M8 carriage head bolts, M8
lock washers and M8 hex nuts to secure the planer to
the stand. Insert bolts down through holes in planer
and stand. Place lock washers then nuts on bolts and
tighten.
4. Attach the shifter knob by screwing it into place at (SS)
Fig. 17.
5. Screw down flange (FF) Fig. 18 of planer head to the
small mounting holes (HH) Fig. 18 in flange and stand.
Insert two M3 Phillips head screws down through holes
(HH) and attach the flange to the stand using two M3
serrated hex flange nuts.
Fig. 16
Fig. 17
HH
11
AA
SS
FF
Fig. 18
HH