Control Unit - Beta 1823 60 Mode D'emploi

INSTRUCTIONS FOR USE
1. Description
The soldering station has been especially designed for soft soldering.
It takes 30 seconds to heat up from room temperature to 350 °C.
communication equipment.

1.1 Control Unit

The soldering iron tool is automatically controlled by the microprocessor. The digital control electronics and high-quality sensor and
heat exchange system guarantee precise temperature control at the soldering tip. The highest degree of temperature precision is
obtained by quick, accurate recording of the measured values in a closed control circuit; hence this model is particularly suitable
for production processes.
1.2 Soldering Iron
The soldering iron has a power of 60 W (heat-up rating 130 W).
The high power and slim design makes this iron suitable for a wide spectrum of soldering tips. The heating element is made of
PTC, and the sensor on the soldering tip can control the soldering temperature quickly and accurately.
Rated voltage range: 220-240 Vac; rated power input: 60 W; 50 Hz.
3.1 Place the soldering iron on its stand. Then connect the plug to the receptacle on the station, and turn clockwise to tighten the
Connect the control unit to the power supply and switch on the power. A self-test is performed, all the display elements being
3.2 Display and temperature setting
The digital display:
1 Shows the actual temperature of the soldering tip.
2 Shows the set temperature. Pressing the "UP" or "DOWN"
cursor key will change the set temperature value.
"UP"/"DOWN" cursor key.
200°C, 300°C, 400°C,keys: Pressing these keys will change
the set point quickly. [°C/ °F]
3 °C/°F display: Switching the temperature display from °C to °F by pressing this key. Hence the electronic system will display
the actual temperature 1 and the set temperature 2 in°F, and vice versa.
4 When the actual temperature on the soldering tip is less than the set point, "HEAT ON" will be displayed, to indicate that the
resistor is in operation.
5 When the offset between the actual temperature and the set point exceeds 10%, "WAIT" will be displayed, to warn the user that
he/she should wait until the two temperatures (set point and actual temperature) become the same.
6 When "ERROR" is displayed, the soldering iron may not be connected to the control unit correctly, or the resistor of the soldering
tip may be broken (probably due to a shock).
Sleeping Mode
The station will automatically go into sleeping mode if the soldering iron is not operated in 15 minutes. The temperature of the
soldering tip will cool down to 200 °C and keep it during the sleeping period, until the station is restarted. After the station has been
restarted, it will go back to the previous working condition.
The soldering station can be restarted using the methods below:
mode again).
Art.1823 60 SOLDERING STATION
EN
5