Network; Messages Relating To Bd Disc And Dvd Disc - Yamaha MCR-940 Mode D'emploi

TROUBLESHOOTING

Network

Problem
Cannot connect to
the Internet.
Cannot download
BD-LIVE contents.

Messages Relating to BD disc and DVD disc

The following messages appear on the TV screen in case the disc you tried to playback is not appropriate or the operation
is not correct.
Error message
Cannot play.
Incompatible disc.
Cannot operate.
This USB memory is
not formatted properly.
Please format the
memory in USB
memory management.
The Connected USB
Memory cannot be
used. It should be
compliant with USB 2.0
46
En
Cause
The network cable is not connected
properly.
The wrong cable is being used, such as a
modular cable.
The broadband router or modem is not
properly connected.
The broadband router or modem is not
turned on.
The network settings are not correct.
The network cable is not connected
properly.
The USB memory device is not
connected properly.
The BD disc does not support BD-LIVE.
"BD Internet Access" is set to "Prohibit".
Possible Error
The disc cannot be played back with this Player.
If you load a disc which cannot be played with this
Player (i.e. a scratched disc), or if you load a disc
upside down, this message will appear, and the disc
tray will automatically pop out.
Occurs if the loaded disc cannot be played because it
is a non-standard disc or scratched, etc.
Occurs if an operation is incorrect.
Occurs if there is a formatting error.
Occurs if the USB memory is not formatted with
FAT 32/16.
Occurs if USB memory not compliant with USB 2.0
High Speed (480Mbit/s) is used (i.e. USB 1.0/USB
1.1).
Remedy
Connect the network cable properly.
Use the network cable for connection.
Connect the broadband router and/or modem
properly.
Turn on the broadband router or modem.
Check "Communication Setup".
Connect the network cable properly.
Check that the USB memory device is connected to
the USB BD STORAGE/SERVICE terminal of the
BD player.
Check if the BD disc supports BD-LIVE.
Set "BD Internet Access" to "Permit" or "Limit".
Check the disc, and load it correctly.
Check the disc, and load it correctly.
Remove the disc.
Format the USB memory again.
Format the USB memory with your PC.
Connect USB 2.0 High Speed (480Mbit/s) compliant
USB memory.
See
page
10
10
10
—
36
10
10
24
35
Remedy