Programme End; Option Buttons - Candy CDP 3T62DFW Mode D'emploi

Changing a running programme
Proceed as follows to change or cancel a
running program:
■ Hold the "RESET" button down for at
least 5 seconds. "00" will appear on the
display and some audible signals will
sound.
■ The running programme will be cancelled.
The display will show two lines.
■ At this point a new programme can be set.
WARNING!
Before starting a new programme,
you should check that there is still
detergent in the dispenser.
If necessary, top up the dispenser.
Programme operations
Whilst a programme is running, the display
shows the time remaining to the end of the
cycle, which is automatically updated.
If there is any break in the power supply
while the dishwasher is operating, a
special memory stores the selected
programme and, when the power is
restored, it continues where it left off.

Programme end

A 5 second alarm will sound (if not muted)
3 times at 30 second intervals to signal that
the programme has ended.
IMPORTANT
If the "SMART DOOR" function is
activated, during the drying phase
the door will open automatically and
you will have to wait until the indication
of the end of cycle before removing
the dishes.

Option buttons

"SMART DOOR" button
(AUTOMATIC OPEN DOOR)
This option activiates a special device that
opens the door a few centimeters during or
at the end of the drying cycle (depending
on the programme). This ensures the natural
and efficient drying of dishes.
The duration of the selected cycle will
automatically
optimiazation of temperatures used during
the rinse phase, this allows a significant
reduction of energy consumption. The
automatic door opening in the last phase of
drying enables the air to circulate,
removing the risk of bad odours.
IMPORTANT
This option is automatically activated
on the "ECO" programme, it is however
possible to disable it.
The function "SMART DOOR" is not
available in the programme "ULTRA
RAPID 24'" and "REFRESH".
ATTENTION
With this option selected, you must
not in any way prevent the door from
opening or force it shut, as this will
damage the mechanism.
Ensure that there is free space in
front of the door and before closing
wait for the return opening device.
17
change to allow an