Operator's Notes; Application; A.1 Intended Use; Danger Notices And Warnings - Renfert Vortex compact 3L Mode D'emploi

The sections below are intended to help operators
make safe and proper use of the unit in their lab.
WARNING
Use these operating instructions to instruct
the operator in the applicable range of op-
eration, the potential risks when operating
the device and how to actually operate the
device.
Always have the user's information ready at hand for
the operator.
A. Application

A.1 Intended use

Use the unit for extracting dry, non-combustible dust
and liquids.
The unit is suitable for commercial use, e.g. in dental
labs.
When used properly, the safety vacuum
cleaner described in this manual is suitable
for vacuuming up dry, non-flammable dusts
and liquids. It is properly suited for the
vacuuming up and off of health endanger-
ing, non-flammable dusts with TLV values
greater than 1 mg/m
dust class 'L' as per EN 60335-2-69.
In order to protect the health of persons
working in a dental laboratory, the law re-
quires that specialised dust extractors must
be used.
National regulations state the MAK value
- maximum concentration of suspended
particles in the air.
Find out about the legal national threshold
value and the type of dust generated in
your laboratory.
Any other use is not „as intended". The manufacturer
shall not be liable for any damages resulting from any
such other use.
The „use as intended" includes compliance with the
operating, servicing and preventive maintenance
conditions defined by the manufacturer.
EN

Operator's Notes

in accordance with the
3
B. Danger Notices and
Warnings
Top part of extractor housing contains live
(conducting) parts.
Contacting live parts will cause serious
injury or death.
Never spray top part of extractor housing
with water.
Risk of electric shock from a broken mains
lead.
Contacting a broken mains lead may cause
serious injury or death.
Avoid damaging the mains lead (e.g. by
pulling, squashing or driving over it).
Regularly check mains lead for damages
(e.g. rips, wear).
Before making further use of the unit, have
the Renfert Service Team or a skilled electri-
cian replace the broken mains lead.
The unit should only be operated using a
mains cable with a country-specific plug
system. Any modification required should
only be carried out by an electrician.
The mains socket on the unit is only de-
signed for the purposes specified in the
Operating Instructions. Connecting other
devices may cause material damage.
Before connecting another device, turn off
both the dust extractor and the other de-
vice.
Read the operating instructions of the other
device and comply with the safety instruc-
tions contained in the document.
Risk of damage by non-compliant mains
voltages.
You may damage the unit if you connect
it to any other than the specified mains
voltage.
Check the type plate to verify that your local
mains voltage matches the rated voltage.
Extracting liquids.
Immediately interrupt the work in prog-
ress and empty the dust retainer when you
notice any foam beginning to form or liquid
escaping.
Regularly clean the built-in water level con-
trol float and check for damages.
- 6 -