Mounting / Exchanging The Saw Blade; Releasing The Retaining Screw / Removing The Old Saw Blade - HEBU medical GOLD II Autopsie Mode D'emploi Et De Service

EN

3 Mounting / exchanging the saw blade

!
If applicable use thick gloves to prevent injury when handling the saw blade.
Only ever connect the HEBU oscillating cast cutting saw to the mains when

3.1 Releasing the retaining screw / removing the old saw blade

1. Place the cast cutting saw on a stable underlay (table).
2. Apply one
and the other one at the front at the retaining screw (see fig. 1).
3. Hold the rear wrench firmly and use it to fix the cast cutting saw.
4. Release the retaining screw using the front wrench.
5. Remove
Ensure that you do not lose any components.
6. If applicable, remove the old saw blade.
18
Danger of injury due to unintentional activation.
Pull out the plug before changing the saw blade.
fork wrench at the
the retaining
Oscillo-Saw GOLD II Autopsy
it is switched off.
drive shaft behind
screw and
Releasing the retaining screw
the saw blade,
the fixing ring.
Fig. 1: