Electrical Safety - Black & Decker ST182320 Mode D'emploi

Chargers
Use your BLACK+DECKER charger
u
only to charge the battery in the tool
with which it was supplied. Other bat-
teries could burst, causing personal
injury and damage.
Never attempt to charge non-recharge-
u
able batteries.
Have defective cords replaced immedi-
u
ately.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The charger is intended for
indoor use only.
Read the instruction manual
before use.

Electrical safety

Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Labels on appliance
The following pictograms are shown on
the tool along with the date code:
Read the manual prior to
operation.
Wear safety glasses or goggles
when operating this appliance.
(Original instructions)
Wear suitable ear protectors
when operating this appliance.
Always remove the battery from
the appliance before performing
any cleaning or maintenance.
Beware of flying objects. Keep
bystanders away from the
cutting area.
Do not expose the appliance to
rain or high humidity.
Directive 2000/14/EC
guaranteed sound power.
Features
This appliance includes some or all of the following features.
1. Trigger
2. Lock off button
3. Handle
4. Auxiliary handle
5. Height adjust collar
6. Trimmer head
7. Edge guide
8. Guard
9. Spool housing
10. Battery
Charging the battery (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell tempera-
ture is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell temperature
warms up or cools down.
Plug the charger into an appropriate outlet before inserting
u
the battery pack.
Insert the battery pack into the charger.
u
The green LED will flash indicating that the battery is being
charged.
ENGLISH
9