Attaching The Brush Head; Charging Your Sonicare; Battery Low; Battery Fully Charged - Philips sonicare HX6322/04 Mode D'emploi

Attaching the brush head

1 Align the brush head so the bristles point in the same direction as
the front of the handle (Fig. 4).
2 Firmly press the brush head down onto the metal shaft until it stops.
Note: There is a small gap between the brush head and the
handle.

Charging your Sonicare

1 Plug the charger into an electrical outlet.
2 Place the handle on the charger (Fig. 5).
The battery charge indicator in the power on/of button lashes and
the handle beeps twice to indicate that the toothbrush is charging.

Battery low

If the battery charge of your Sonicare is low, you hear three beeps
and the battery charge indicator lashes rapidly for 1 minute after the
brushing cycle.

Battery fully charged

When the Sonicare is fully charged, the battery charge indicator stops
lashing and remains on for 10 seconds before it turns of.
To keep the battery fully charged at all times, you may keep your
Sonicare on the charger when not in use. It takes at least 24 hours to
fully charge the battery.
Note: When the battery charge is depleted, the handle will emit 2 sets of
5 beeps at the end of a brushing session or when a new brushing session
is attempted. The new brushing session does not begin. The green LED
will also flash fast until the handle goes to sleep.
35_020_9980_1_DFU-BS_A6_v1.indd 11
English
11
18/12/15 13:46