After End Of Use; Points To Note At The End Of Use - Schluter Systems LIPROTEC-EASY Mode D'emploi

LIPROTEC-P Operating Instructions
Fault description
Radio remote control
not working
Mobile device does not
establish any connec-
tion with the Bluetooth
receiver
7

After end of use

7.1 Points to note at the end of use

If the LIPROTEC-EASY system is not to be used any further, it must be disconnected from
the voltage supply under all circumstances.
1. Unplug the mains plug of the power supply.
> The power supply is no longer supplied with mains voltage and all connected compo-
nents are permanently free of voltage.
Cause
Battery empty
Connection between the
radio remote control and the
receiver interrupted
Radio remote control faulty
Bluetooth receiver faulty
Favourites have been
deleted.
Bluetooth not activated on
the Bluetooth receiver
Bluetooth deactivated on
the mobile device
Volume set to "silent" on the
mobile device
DANGER!
Danger to life due to disassembly in the presence of
electrical voltage!
If system components and, specifically, the power supply are disassem-
bled while they are energised, this can result in life-threatening electric
shocks.
– First unplug the mains plug of the power supply, then disassemble it.
Remedy
Change the battery » "Changing
the battery" on page 61.
Teach the radio remote control
again » "Teaching the radio re-
mote controls" on page 60.
Replace the radio remote
control.
Replace the Bluetooth receiver.
Set favourites up again using
the Schlüter -LED-Color-Control
®
» "Operation via Schlüter
Color-Control" on page 60.
Activate Bluetooth pairing on the
Bluetooth receiver » "Activating
Bluetooth pairing on the Blue-
tooth receiver" on page 60.
Activate Bluetooth on the mobile
device in accordance with the
specifications of the device
manufacturer.
Increase the volume.
EN
-LED-
®
63