ClassicFlame 23II042FGL Mode D'emploi page 6

OPERATION INSTRUCTIONS
SAFER PLUG
SAFER SENSOR
A6051
This product is equipped with a safer Plug; an advanced safety device that
helps detect electrical fires caused from faulty outlets.
Overloading of outlet, adapters and surge protectors may cause overheating,
damage, and increase risk of fires. Safer Plug continuously monitors the tem-
perature in the plug and outlet and will turn off the heater to prevent unsafe
outlet overheating.
If the Safer Plug cuts the power due to unsafe conditions it will show an
" "message on the screen. If this occurs the Safer Plug has prevented a
potentially unsafe condition.
To reset the device if this occurs, first allow the plug to cool down. Once the
plug has cooled down, unplug the device and wait 5 seconds, then plug back
in and continue to use normally.
If the Safer Plug continues to activate your outlet may be faulty. Check your
heater cord and plug connections. Faulty wall outlet connections or loose
plugs can cause the outlet or plug to overheat. Be sure the plug fits tight in the
outlet. Heaters draw more current than small appliances, overheating of the
outlet may occur even if it has not occurred with the use of other appliances.
During use check frequently to determine if your plug outlet or faceplate is
HOT! If so, discontinue use of the heater and have a qualified electrician
check and/or replace the faulty outlet(s).
This product is equipped with a Safer Sensor; an advanced safety device that
helps prevent heaters from being accidently covered or blocked causing a
potentially unsafe condition.
The SAFER SENSOR detects if an object is too close to the front of the heater
potentially obstructing the air outlet. If blocked, the control panel will flash
" " icon and the heater will be turned off. Once the object has been
moved and after user presses the power button, "
unit will be back on the previous setting with the heat on.
6
" will disappear and the
www.tsicustomerservice.com