Safety Notes - Kränzle K 1050 TST Manuel D'utilisation

Safety notes

User operating the high pressure cleaner should wear the necessary protective
clothing, i.e. waterproof clothing, rubber boots, safety goggles, headwear etc.
It is prohibited to use the high pressure cleaner in close vicinity to people lacking
suitable protective clothing.
Do not spray against matter containing asbestos or other hazardous substances!
Never spray liquids containing solvents like varnish solvents, petrol, oil or similar
liquids! There is an explosion hazard due to spraying such materials!
Due to the high pressure jet, damage may occur on the objects to be cleaned,
e.g. car tires; therefore, a minimum distance of 30 cm is to be kept!
Prior to putting the high pressure cleaners into operation, check its components
(High pressure hose, power supply cables, safety trigger gun) for any damage.
Replace defect or damaged components!
Replacement of the power supply cables is only permitted by use of an original
power supply cable of the manufacturer and must be performed by a qualified
electrician.
The high pressure cleaner is to be properly used. The user is required to adhere to
local requirements and to watch out for the persons in the danger zone!
The high pressure cleaner is not intended for use by persons with reduced
physical, sensory or mental capabilities, unless such persons are supervised and
capable of perceiving the risks involved in the use of high pressure cleaners!
32
Safety notes - This is prohibited!
When using high pressure water for clea-
ning, make sure that there is a clearly noti-
ceable recoil effect on the lance. Therefore
ensure a firm footing (see technical data).
Never allow children or untrained persons
to use the high pressure cleaner or to play
with it!
Never direct the high pressure jet at the
high pressure cleaner itself!
The high pressure cleaner may not be
placed within reach of the high pressure jet
spray mist!
Never direct the high pressure jet at power
sockets or any other electrical installations!
Within the working area, all live parts are to
be protected from both water jet and spray
mist.
GB
33