Care And Cleaning - Petsafe PDT20-10644 Manuel D'utilisation

3. The Receiver Collar should fi t snugly, yet
loose enough to allow one fi nger to fi t
between the collar and your pet's neck (3C).
4. Allow your pet to wear the collar for several
minutes then recheck the fi t. Check the fi t
again as your pet becomes more comfortable
with the Receiver Collar. If your pet's neck is
less than 300 mm around, you will need to
thread the part of the collar which includes
the antenna through the buckle. It will be a
tight fi t.
CAUTION
contact. A collar that is too tight will increase the risk of pressure necrosis in the
contact area.
5. Trim the collar as follows (3D):
a. Mark the desired length of the collar with a pen. Allow for growth if your pet is
young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet
and cut off the excess. Important: Do not
cut the part of the collar containing the
Antenna.
c. Before placing the Receiver Collar back
onto your pet, seal the edge of the cut collar
by applying a fl ame along the frayed edge.

Care and Cleaning

• Your dog's neck and the Contact Points must be washed weekly with a damp cloth.
• Be sure that your pet's neck is thoroughly dry before placing the Receiver Collar back
on his neck.
CAUTION
• For comfort, safety and effectiveness of this product, please ensure that you check
the fi t of your pet's collar frequently. If any skin irritation is observed, discontinue the
use of the collar for a few days. If the condition persists beyond 48 hours, see your
veterinarian.
• Do not attach a lead to the collar. This can result in pulling the Contact Points too
tightly against your pet's neck. Attach a lead to a separate, non-metallic collar or
harness, making sure the extra collar does not put pressure on the Contact Points.
10
You should not make the collar any more tight than is required for good
Risk of skin damage.
www.petsafe.net
3C
3D