Codes Reported In The Field "Faults" Of The Events History - Mocom Millwashing Manuel D'utilisation

CODES REPORTED IN THE FIELD "FAULTS" OF THE EVENTS HISTORY

The result of the performed cycle is signalled in the field "Faults" of the events history with a numeric code that takes into
account possible events occurred during the operation that caused a blocked status:
Code Meaning
01 cycle ok
Code Meaning
00 power fail
02 failed disinfection
03 Door unblocked
04 Door open
07 water lack
08 Resistor failure
09 probe 1 failure
10 Serial interface failure
12 Pump failure
15 drain pump failure
16 chemicals lack
18 Drying blocked
(for units equipped with the forced drying option)
21 Probes mismatch
22 Sterilizer probe 2 failure
25