Clean The External Surfaces; Clean The Control Panel; Clean The Nozzles; Disinfect The External Surfaces - Mocom Millwashing Manuel D'utilisation

Clean the external
surfaces
Clean the control
panel

Clean the nozzles

Disinfect the
external surfaces
Clean/replace the
handpiece and
accessory holder
Regenerate the
water softener
20
Clean all external surfaces with a clean cloth dampened with water, possibly adding weak
neuter detergent.
Wipe all surfaces and remove any residue before using the unit again.
Clean the control panel with a soft clean cloth dampened with a product for plastic or other
disinfectant suitable for this use.
To eliminate scale traces from the nozzles of the rotating arms, use a clean cotton cloth
soaked with a weak solution of water and vinegar (or similar product, after first checking its
contents on the label).
-
Remove the washing arms.
-
To make the cleaning of the arms inside easier, unscrew and remove the two caps
placed at their ends.
-
Remove any scale residue.
To disinfect external surfaces use denatured alcohol or products composed with a
minimum percentage of sodium hypochlorite.
Separate the parts that make up the handpiece holders and place all the accessories in a
container filled with a weak solution of water and vinegar. Let the solution dissolve the
scale deposits. Wash under current water and dry.
Replace the internal filter of the handpiece holder if it is no longer recoverable.
When the display shows the message "SALT LOAD" or "CLN" it is necessary to load salt
into the unit; proceed as follows:
-
Open the washing compartment door.
-
Unscrew the plastic cap of the salt container placed inside.
-
Pour about 0.5Kg of common kitchen salt into the container using the funnel
provided.
DO NOT POUR SALT OUTSIDE THE CONTAINER.
-
Screw the plastic cap back.
-
Carry out a normal load of material to be washed and start a normal cycle.
The unit will automatically perform the regeneration of the water softener.
T
HE FIRST WASHING CYCLE STARTED AFTER THE REGENERATION IS LONGER AND
APPARENTLY PRESENTS AN INITIAL IDLE STAGE DURING WHICH THE UNIT PERFORMS
THE REGENERATION PROCESS
"REG".
MESSAGE
WARNING
NOTE
. D
URING THIS PHASE THE DISPLAY SHOWS THE