Balluff BIP LD2-T017-01-EP-S4 Série Notice D'utilisation page 50

BIP LD2-T017-01-EP _ _ / EP _ _ -S4
Inductive Positioning System
6
IO-Link interface (continued)
Single-point mode
Hysteresis
SSC
ON
SP1
Fig. 6-2: Example for presence detection in single-point mode
1. Select switching channel.
2. Move the target to the desired switching point SP1 (SP1 must
lie within the operating range).
3. Send system command.
4. Set hysteresis (in example for SSC1).
5. Check teach-in status (as needed).
Two-point mode
The sequence of commands is critical,
otherwise you will only accomplish single-point
calibration!
Hysteresis
SSC
ON
SP2
Fig. 6-3: Example for presence detection in two-point mode
1. Select switching channel.
2. Move the target to the desired switching point SP2 (SP2 must
lie within the operating range).
3. Send system command.
4. Move the target to the desired switching point (SP1 must lie
within the operating range and be greater than SP2).
5. Send system command.
18 english
OFF
Position value
OFF
Position value
SP1
Index Subindex Access
0x003A 0x00 R/W
0x0002 0x00 W
0x003D 0x03 R/W
0x3B 0x00 R
Index Subindex Access
0x003A 0x00 R/W
0x0002 0x00 W
0x0002 0x00 W
Data
0x01: SSC1
0x02: SSC2
0x03: SSC3
0x04: SSC4
0x41
50...16900 μm
0x11
Data
0x01: SSC1
0x02: SSC2
0x03: SSC3
0x04: SSC4
0x42
0x41