Osram AirZing PRO 5040 Mode D'emploi page 3

NOTICES
This product must be installed properly, please refer to installation instructions to
―
prevent damage to the light source or other components.
The product needs to be installed at certain height and space within specified
―
temperature. IR sensor might be activated in case of unusual air convections.
Insufficient UV-C dose may not achieve the intended purification effect.
―
The UV intensity of this product is determined according to the service time. When
―
the accumulative service time of the UV-C lamp exceeds its effective lifetime, please
replace the lamp in time.
UV-C can age non-metallic materials such as plastics, rubbers etc. Shield all
―
non-metallic materials exposed under UV-C light when using the product.
Never expose plants to UV-C light.
―
When using this product, keep the germicidal space clean and dry, close the doors
―
and windows, and avoid outdoor air circulation. Do not use wind speed regulator.
This product is ozone free.
―
The original design and testing of this product are based on OSRAM HNS T8 36W
―
double-end UV lamp tube. It may perform in different ways if with any other light
sources.
OSRAM HNS tube contains mercury; please follow local regulations when disposing
―
of used light source.
A 5-second break is required before switching on again right after switching off, due
―
to 3 to 5-second systematic resetting.
Once the product is switched off by IR sensor, it will not switch on automatically, it
―
needs to be turned on manually.
Please refer to the below QR code for product warranty policy. The OSRAM warranty
policy would only apply to products that has been installed, used, repaired and
maintained properly according to this manual. Failure to observe this requirement
shall void any warranty, stated or implied.
REMARK
UV-C
RoHS