Optional Functions - Campomatic WD 950 E Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

USING THE WASHING MACHINE

The machine offers a wide selection of spin speeds that can be selected before star-

ting the wash programme.To change the spin speed, simply press button (H) until the

value required is displayed. The corresponding led will light up each time the button

is pressed. If the spin is to be excluded, press the button until the led corresponding

to the No Spin symbo

NB. The maximum spin speed will vary according to the model and is

indicated in the technical characteristics table of the washing machine.The

maximum recommended spin speed for each programme is that displayed

automatically when the wash programme is selected.

Load imbalance check during spinning:

This washing machine is ﬁtted with a special electronic load balancing control system. Before each

spin, the system makes sure that the clothes are distributed as uniformly as possible in the drum. If

the washing is not distributed uniformly, the ﬁnal spin speed is reduced for safety reasons, while if

the load is drastically out of balance, the spin is not effected.

The washing machine is equipped with a function that allows the start of the wash

to be delayed for up to a maximum of 8 hours. The delay time is selected as follows:

each time button (I) is pressed, the wash will be delayed by 1, 2, 4, 8 hours. Once

start button (L) has been pressed, either the selected led or button (I) will ﬂash

(according to the model) to indicate that the function has been enabled. The wash-

ing machine will now automatically start the wash cycle after having waited for the

number of hours set.

(This function is also useful for users with off-peak electricity).

After all the operations described in points 1 to 8 of paragraph "WASH CYCLE" have

been carried out, pressing this button will start the wash cycle.

The relative indicator light will light up after approximately 2 -3 seconds to indicate

that the door is locked and the wash programme has started.

The stop function resets the washing machine. If, for any reason, you want to change

the wash programme or add more washing to the load during the wash cycle, simply

place the programmer knob in position "STOP". The "START" led will switch off.

Then re-position the knob on the new programme and press the "START" button.

Warning!! Only use this function if strictly necessary and then only if the programme to reset

has not been running for more than 3 minutes. Before opening the door after a reset, wait 2

minutes for the locking mechanism to release.

If one of the following buttons is selected, the relative led will light up. If a function button has

been pressed by mistake or is no longer required, the option can be cancelled by simply repress-

ing the button.

VARIABLE SPIN:

l (where present) or No Spin label, lights up.

DELAYED START:

START BUTTON:

PROGRAMMER KNOB "STOP":