Optional Functions - Campomatic WM850E Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

VARIABLE SPIN:

The machine offers a wide selection of spin speeds that can be selected beforehand according

to the wash programme. To change the spin speed, simply press button (H) to select the required

speed. The corresponding speed led will light-up each time the button is pressed. To exclude

the spin, select the led corresponding to symbol

NB. the maximum spin speed will vary according to the model and is indicated by the Leds on the

machine. The maximum spin speed that can be selected for each programme is indicated by the leds

that light-up automatically when the wash programme is selected.

Spin load imbalance control:

This washing machine is equipped with a special electronic control system for correctly balancing

the wash load.

Prior to each spin, the system ensures that the washing is evenly distributed in the drum.

If the washing is not evenly distributed, the final spin speed is reduced, and if the load is very

unbalanced, the spin is not effected.

DELAYED START:

The machine is fitted with a delayed start function. This allows the washing machine to be

programmed to start the wash cycle up to 8 hours later. The delay in hours can be selected

as follows: press the button to set a delay of 1, 2, 4, 8 hours. When the START button

(L) is pressed, the selected led will flash or button (I) will light up (according to the

model), signalling that the function has been activated. The machine will wait for

the number of hours set to elapse and then start the wash cycle automatically.

START BUTTON:

After having carried out all the operations described in points 1 to 8 in the paragraph

"WASHING CYCLE" press this button and the washing machine will begin its washing cycle.

The relative LED will light up after 2-3 seconds, to indicate that the door is locked and the

program has started.

PROGRAMMER KNOB "STOP":

The stop function resets the washing machine. If, for any reason, you want to

change the wash programme or add more washing to the load during the wash

cycle, simply place the programmer knob in position "STOP", then re-position the

knob on the new programme and press the "START" button.

Warning!! only use this function if strictly necessary and then only if the programme to reset has

been running for a few minutes. Before opening the door after a reset, wait 2 minutes for the

locking mechanism to release.

If one of the following buttons is selected, the corresponding LED will switch on. But if it has been

selected by mistake or you have changed your mind, simply press it again to cancel the selection.

PREWASH:

Press this button to run a short wash at a maximum temperature of 40°C of approximate

duration 10 minutes. This function can only be used with the "COTTON" and "SYNTHETIC"

programmes and DAILY"

N.B. When using this function, remember to put some detergent in the pre-

wash compartment too.

ENERGY WASH:

Press the button and the machine will carry out a wash cycle at the set temperature but

lasting longer.

The button is active with "COTTON" and "SYNTHETICS" programs.

USING THE WASHING MACHINE