Optional Functions - Campomatic WM111XL Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

USING THE WASHING MACHINE

The machine offers a wide selection of spin speeds that can be selected beforehand according to the

wash programme. To change the spin speed, simply press button (H) to select the required speed. The

corresponding speed led will light-up each time the button is pressed. To exclude the spin, select the led

corresponding to symbol , if present, or the writing "no-spin".

NB. the maximum spin speed will vary according to the model and is indicated by the Leds on the machine.

The maximum spin speed that can be selected for each programme is indicated by the leds that light-up

automatically when the wash programme is selected.

This washing machine is equipped with a special electronic control system for correctly

balancing the wash load. Prior to each spin, the system ensures that the washing is evenly

distributed in the drum. If the washing is not evenly distributed, the final spin speed is

reduced, and if the load is very unbalanced, the spin is not effected.

The machine is fitted with a delayed start function. This allows the washing machine to be programmed

to start the wash cycle up to 8 hours later. The delay in hours can be selected as follows: press the but-

ton to set a delay of 1, 2, 4, 8 hours. When the START button (L) is pressed, the selected led will flash

or button (I) will light up (according to the model), signalling that the function has been activated. The

machine will wait for the number of hours set to elapse and then start the wash cycle automatically.

After having carried out all the operations described in points 1 to 8 in the paragraph "WASHING

CYCLE" press this button and the washing machine will begin its washing cycle. The relative LED

will light up after 2-3 seconds, to indicate that the door is locked and the program has started.

The stop function resets the washing machine. If, for any reason, you want to change the wash pro-

gramme or add more washing to the load during the wash cycle, simply place the programmer knob

in position "STOP", then re-position the knob on the new programme and press the "START" button.

Warning!! only use this function if strictly necessary and then only if the programme

to reset has been running for a few minutes. Before opening the door after a reset,

wait 2 minutes for the locking mechanism to release.

If one of the following buttons is selected, the corresponding LED will switch on. But if it has been

selected by mistake or you have changed your mind, simply press it again to cancel the selection.

Press this button to run a short wash at a maximum temperature of 40°C of approximate duration

10 minutes. This function can only be used with the "COTTON" and "SYNTHETIC" programmes

and DAILY"

N.B. When using this function, remember to put some detergent in the pre-

wash compartment too.

Press the button and the machine will carry out a wash cycle at the set temperature but lasting

longer.

The button is active with "COTTON" and "SYNTHETICS" programs.

VARIABLE SPIN:

SPIN LOAD IMBALANCE CONTROL:

DELAYED START:

START BUTTON:

PROGRAMMER KNOB "STOP":