Remote Control - Honeywell CS10XE Série Mode D'emploi

USE & OPERATION (CONTINUED)

REMOTE CONTROL

NOTE:
• The remote control requires a CR2032 (1 x 3V) coin type or equivalent battery for replacement.
• Open the battery compartment at the back of the remote control and insert the battery inside.
Care must be taken to insert the batteries according to the correct polarity (+ / –) markings
shown inside the battery compartment.
• Always point the remote control signal transmitter towards the unit when operating. Make sure
that the signal path is not obstructed.
• Remove the batteries if the unit is not going to be used for an extended period of time.
• Do not drop the remote control.
• Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
• Do not mix old and new batteries.
• Do not recharge the battery.
• Exhausted batteries are to be removed from the product and safely disposed of as per local
regulations.
• Do not dispose of batteries in fire. Batteries may explode or leak.
• This product contains a lithium button/coin cell battery. If a new or used lithium button/ coin
cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to
death in as little as 2 hours. Always completely secure the battery compartment. If the battery
compartment does not close securely, stop using the product, remove the batteries, and keep it
away from children. If you think batteries might have been swallowed or placed inside any part of
the body, seek immediate medical attention.
• The batteries shall be disposed of properly, including keeping them away from children.
• Even used batteries may cause injury.
WARNING: Chemical Burn Hazard. Keep batteries away from children.
POWER : ON / OFF
SPEED : Low / Medium / High / Sleep*
COOL : Evaporative Cooling ON / OFF
SWING : Controls the motion of the louvers
TIMER : Controls the Timer function for automatic off
EN 4
*Applicable for models with Sleep feature only.