Initial Use; Installing The Control Unit; Wall Mounting - Beurer BF 100 Body Complete Mode D'emploi

5

Initial use

Inserting batteries
Remove the batteries from the protective
packaging and insert them into the scale
and control unit according to the polarity
indicated. See the diagram inside the
battery compartment. Once you have
inserted the batteries, the year flashes on
the display, see page 29.
Control unit
6

Installing the control unit

Setting up the control unit
You can either hold the control unit in
your hand, set it on a level surface or
keep it on the scale.
Slide out the tray (on the rear of the sca-
le) as shown to place the control unit on
the scale. The tray contains a magnet that
fixes the control unit to the scale.
26
3 x AA
www.TopSport.com.ua
Scale
3 x AA
If the scale and the control unit do not func-
tion, remove the batteries completely and
reinsert them.
For instructions on changing the batteries,
see p. 39.
Setting up the scale
Set up the scale on a level and solid sur-
face. A solid surface is a prerequisite for a
correct measurement.

Wall mounting

The control unit can be mounted on the
wall using the mounting kit (wall holder,
screws, wall plugs). Use the mounting kit
provided and install the wall holder as
shown. Use wall plugs that are suitable
for the surface onto which it is to be
mounted.
• Use the wall holder as a template to
mark where the holes are to be drilled.
• Use a 6 mm drill to drill 2 holes in the
wall that are approximately 40 mm deep
and 36 mm apart at the same height.
• Insert the wall plugs.
Beurer BF 100