Control Panel "Pc380-St; Descriptions - CBE PC380-ST Instructions D'emploi

CONTROL PANEL "PC380-ST"

DESCRIPTIONS

1) 12V button (lights, 12V sockets electric
"SAT" and awning light).
2) Button to switch the pump on and off.
3) Awning light button; this
automatically off when you start up the engine
(it depend on the 12V button).
Button with integrated twilight sensor to set
4)
the intensity of the LED backlighting in a
"night"
situation (see also the "TWILIGHT" function).
5) On/off main button (to turn on/off press for 2
seconds) at the start-up the display carries :
out a functioning test and shows all symbols
(including unused symbols).
If the relevant LED is green the control panel
is on, if it is red an alarm is on (batteries,
tanks, etc.).
1 2
1 2
5 6
, antenna
awning light switches
3 4
3 4
7 8
6) "PROG" button for system
SETTING).
Button for the control of fresh water tank (in
7)
%), for fresh water refilling function operation
(see "FRESH WATER TANK REFILLING"
function) and for the regolation of the
programmable parameters' setting (see
SETTING).
8) Button for control of car and leisure batteries
voltage (in Volt) and for the regolation of the
programmable parameters' setting (see
SETTING).
NOTE: The watch is supplied from the leisure
battery (B2). Should B2 be disconnected,
the watch is able to keep working, without
visualization, for about
EN
setting (see
2 week .
17