Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cleaning the Base / Transducer / Filter
- Please be careful when cleaning the unit. Any water splashing inside the base may
damage the unit;
- Make sure the unit is turned off;
- Empty the water from the base;
- Use a towel to wipe clean the base. Do not use organic solvent like alcohol or
acetone to clean the base;
- To clean the transducer, pour some white vinegar on the transducer;
- Fill a small amount of warm water and wait for 3 to 5 minutes;
- Clean the transducer by using the included brush;
- Rinse clean the transducer;
- To clean the lter, simply dip the lter in white vinegar for 10 minutes and rinse clean
with water.
Caution
- Please do not dismantle the product by yourself, always ask professional electrician or
authorized technician for repairing;
- If you smell bad odor or anything unusual, please turn off the unit immediately;
- Please do not remove the power plug with wet hands as it may cause electrical shock;
- It is not a toy. Keep away from children;
- Do not place this unit on sloping or uneven surface to avoid water leaking or
component damage;
- Do not put this unit near any heat source or under direct sunlight;
- Keep away from other electric appliances that are prone to humidity damage;
- Using the unit in a space larger than 150m
- Regularly clean the unit if it won't be used for a long period; store in a
dry and shady place.
3
will reduce its effectiveness;
Trouble Shooting Guide
Problem
Possible Cause
No power supply
LED indicator is off, the
unit does not work
Unit not powered on
No water in water tank
LED indicator is red, but
Too much water in the
no mist or wind
water sink
LED indicator and the
Mist output is set to the
wind are on but no mist
lowest level
LED indicator is on and
the water tank has water,
Floater is jammed
but it shows there is no
water
New unit
Bad / Strange smell
Dirty water or the water
has extended its storage
period
Stain built up on the
transducer
Dirty water or the water
The mist output is too
has extended its storage
small
period.
The water is too cold
Solution
Connect power supply
Power on the unit by
turning the switch
Fill water into water tank
Pour out some water from
the water sink and close
the cover of water tank
tightly.
Adjust the mist output
Stir the oater to keep it
owing smoothly
Take out water tank, open
cover. Put it in the room
without any operation for
at least half an hour
Clean water tank, re ll
with clean water
Clean the transducer
Clean water tank,
change to fresh and
clean water
Add some warm water
inside
05/06
Publicité
Table des Matières
