Cleaning The Water Tank; Troubleshooting Guide - TaoTronics TT-AH005 Manuel D'utilisation

Cleaning the Water Tank

1. Make sure the unit is turned off.
2. Remove the water tank from the base.
3. Rinse the tank with clean water and wipe off any water on the outside of
the tank before putting it back.
Cleaning the Base / Transducer / Filter
• Please be careful when cleaning the unit. Any water splashing inside the
base may damage the unit.
• Make sure the unit is turned off.
• Empty the water from the base.
• Use a towel to wipe clean the base. Do not use organic solvents like
alcohol or acetone to clean the base.
• To clean the transducer, pour some white vinegar on the transducer.
• Fill with a small amount of warm water and wait for 3 to 5 minutes.
• Clean the transducer by using included brush.
• Rinse clean the transducer.
• To clean the lter, simply dip the lter in white vinegar for 10 minutes and
rinse clean by water.
Caution
• Please do not dismantle the product by yourself, always ask a professional
electrician or authorized technician for repairs.
• If you smell bad odor or anything unusual, please turn off the unit
immediately.
• Please do not remove the power plug with wet hands as it may cause
electrical shock.
• It is not a toy. Keep away from children.
• Do not place this unit on a slope or uneven surface to avoid water leaking
or component damage.
• o not put this unit near any heat source or under direct sunlight.
• Keep away from other electric appliances that are prone to
humidity damage.
• Using the unit in a space larger than 150m³ will reduce its effectiveness.
• Regularly clean the unit if it won't be used for a long period; store in a dry
and shady place.

Troubleshooting Guide

Problem Possible Cause
No power supply
LED indicator is off, the
unit does not work
Unit not powered on
No water in water tank
LED indicator is green,
but no mist or air
Too much water in the
current
water sink
LED indicator and the
Mist output is set to
air current are on but
the lowest level
no mist
LED indicator is on
and the water tank
Floater is jammed
has water, but it shows
waterless
Solution
Connect power
supply
Power on the unit by
turning the switch
Fill water into water tank
Pour out some water
from the water sink
and close the cover of
water tank tightly.
Adjust the mist output
Stir the oater to keep
it owing smoothly
05/06