Technical Specification - Velleman CAMSCC17 Notice D'emploi

•
[E] Power LED indicator, is on during normal operation.
•
[F] DC12V input. Connect a regulated 12VDC power supply (not
incl.) to provide power to the camera.
•
[G] Video output connector to connect the camera to a monitor
(not incl.)
•
[H] selection dipswitch
• AES/AI selector. Switch to
fixed or manual iris lens is used with this camera. Switch to
Auto Iris (AI) when using an auto iris lens.
• BLC/OFF selector. Switch BLC (Back Light Compensation) on or
off. Set to on when under strong light conditions, set to off
under normal conditions.
• AGC/MAX selector. Set AGC (Automatic Gain Control) to normal
or to maximum.
• FL 1/100 /OFF selector. Set Flicker Less (FL) mode to FL 1/100
(shutter fixed at 1/100 of a second), or switch this feature OFF.
• [I] Iris VD/DD selector. Set to Video Drive (VD) when using a
video drive auto iris lens, or to Direct Drive (DD) in case a direct
drive auto iris lens is used.
• [J] Audio output connector. Connect the audio in of the monitor to
this connector.
6. Connection
• Mount a lens (not incl.) on the camera.
• Set the selection dipswitch [H].
• Connect the video output [G] to the video input of a monitor (not
incl.). Use a 75Ω coaxial cable (not incl.).
• Connect the audio output [J] with the audio input of a monitor
(cable not incl.).
• Connect a 12VDC power supply (not incl.) to the power input [F].
• When using a video driven lens, connect the video drive cable
(not incl.) to the auto iris lens connector [C]. If necessary,
replace the cable connector by the included cable connector.
Refer to the drawing on page 2 of this manual for the pin layout.
Replacing the connector should be done by a qualified technician.
• To adjust the focus of the camera, loose the lock screw [B] on
the flange adjustment ring [A], turn the ring until the desired
focus is reached and retighten the lock screw [B]. Adjusting the
focus should be done by a qualified technician.
7.

Technical Specification

pick-up element
number of pixels
Resolution
min. illumination
S/N ratio
electronic shutter
iris mode
video output
lens mounting
BLC
gain control
flickerless mode
power supply
dimensions
weight
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulted from (incorrect) use of this device. For more info
12/05/2010
CAMSCC17
Auto Electronic Shutter
1/3" HR colour CCD image sensor
753 (H) x 582 (V) - PAL
520 TV lines
0.3 lux / F2 .0
> 48dB (AGC off)
1/50 to 1/100.000 sec
AES / VD / DD selectable
1Vpp, 75 ohms
CS mount
on/off
AGC/MAX
ON/OFF
12VDC ± 10% / 80mA regulated (use
PS1205R, not incl.)
117 x 60 x 50mm
250g
4
(AES) when a
®
©Velleman nv