Getting Started - Denver CRP-618 Mode D'emploi

Power connection
Plug the AC power cord to a household outlet AC source. This unit
is equipped with a battery backup system, it requires a 3V CR2032
flat lithium battery (not included). Insert the battery in the battery
compartment, making certain that the positive and negative (+ and -)
battery terminals are attached to the corresponding terminals on the
plate in the battery compartment. If an AC power failure occurs, the
clock automatically switches to the battery power supply, the clock and
timer memory continue running. When the AC power resumes, the
clock switches back to AC again.

Getting started

1. TIME AND CALENDAR MANUAL SETTING
Setting Time and Calendar
A. Press CLK.ADJ. (10) button in standby mode and keep depress
over 3 seconds to enter time set mode, after enter the setting
mode, press CLK.ADJ. button (10) to change the mode cycle as
follows
Normal → Year → Month → Day → 12/24 H → Real time Hour → Real
time Min → Normal
Action (during data adjustment):
- Press << / Tune - button (11) to adjust data backward.
- Press >> / Tune + button (12) to adjust data forward.
- Keep depress << or >> button for 3 seconds to enable auto
forward.
Press the alarm set button (13/14) during normal mode to show the
alarm time. Afterwards keep depress the alarm set button (13/14) over
2 seconds to enter the alarm set mode. After enter the setting mode,
press the alarm set button (13/14) to change the mode cycle as follows
:
Normal → AL 1 Hour → AL 1 Min → AL 1 weekday Alarm → AL 1
wake beep → AL 1 wake radio → AL 1 wake radio volume → Normal.
Normal → AL 2 Hour → AL 2 Min → AL 2 weekday Alarm → AL 2
wake beep → AL 2 wake radio → AL 2 wake radio volume → Normal.
ENG-2