Using The Memo Touch Control - De Dietrich DTV 724 X Guide D'installation Et D'utilisation

9964-2701_ML.qxp 06/04/2007
EN 2 / USING YOUR APPLIANCE
• •
USING THE MEMO BUTTON
This touch control allows you to programme
the full cooking cycle for a particular prepara-
tion. Only one programmed cycle can be car-
ried out at a time.
• • Operation: :
- From 1 to 5 successive cooking phases can
be saved in the same "MEMO" cooking cycle.
If you exceed 5 phases, a triple beep sounds,
and it stops recording.
- The duration of each phase must be at least
10 seconds for it to be entered into the pro-
gramme.
- The timer can only be used during the last
phase of programmed cooking.
• • To programme a cooking cycle:
1 1 - Place your cookware on the cooking zone.
2 2 - Turn on the hob.
3 3 - Press briefly the touch control M
4 4 - Set the power level for the first cycle for the
burner you have chosen, for which you want
to programme a cooking cycle.
5 5 - Set the zones with extension if necessary;
adding or removing extensions will not be
taken into account in the other cycles.
6 6 - Continue cooking; each new setting will be
recorded as well as the cooking time.
7 7 - The dot keeps flashing so long as you keep
programming. Confirm and stop the program-
ming by pressing the stop touch control
A A n n i i n n d d i i c c a a t t o o r r i i n n t t h h e e t t i i m m e e r r z z o o n n e e s s h h o o w w s s
t t h h e e b b u u r r n n e e r r y y o o u u h h a a v v e e p p r r o o g g r r a a m m m m e e d d . .
Warning
When using a zone with extension,
you can choose the zone only when set-
ting the first cycle.
16:17 Page 26
• • Using a programmed cycle:
1 1 - Place your cookware on the cooking zone.
2 2 - Turn on the hob.
3 3 - Press briefly the touch control M
A fixed dot will appear beside the Memo
touch control at the burner concerned; the
recorded power levels are displayed.
The recorded zone with extension will start
automatically.
The power and timer displays become
steady; cooking starts.
An indicator
the burner you have programmed.
N N O O T T E E : :
- When the cooking finishes, the display
shows 0 0 and a beep sounds about every 5
M
E O
seconds for a little while.
To cancel these indications, press any touch
control for the cooking zone M
- When using M
to normal operation (except M
sing the touch controls "-", "+" "preselec-
tions" to change your setting, or "stop" to
stop your cooking.
• • Replace an existing cooking
cycle program:
1 1 - Place your cookware on the cooking zone.
2 2 - Turn on the hob.
3 3 - Press and hold the touch control M
4 4 - Set the power level for the first cycle for the
burner you have chosen, for which you want
to programme a cooking cycle.
Each new power level setting is then saved as
well as how long it will run for.
The dot flashes while you are programming.
Confirm and stop the programming by pres-
sing the stop touch control
26
M
E O
in the timer zone shows
M .
E O
M you can return at any time
E O
M ) by pres-
E O
M
E O