Table des Matières
Publicité
4.
Installation
Guidelines
•
The construction to which the device is attached should be able to support 4 times
the weight of the device for one hour without deformation.
•
Never stand directly below the device when it is being mounted, removed or
serviced. Have a qualified technician check the device once a year and once before
you bring it into service.
•
Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used... Have the material and the device
itself checked regularly. Do not attempt to install the device yourself if you lack
these qualifications as improper installation may result in serious injuries.
•
This device is not suitable for dimming.
Distances
•
Keep at least 20 cm distance at the top and 30 cm on either side.
•
Respect a minimum distance of 0.5 m between the device's light output and any
illuminated surface.
Choosing an Appropriate Location
•
You can adjust the detection area according to your needs: turn the device to the
left or right and aim it up or down. Note that the detector is much more sensitive to
objects moving across the detection area than it is to objects coming straight at it.
This is a very important consideration when selecting the mounting location.
•
Please avoid installing the floodlight upside-down in order to ensure its
watertightness.
•
The floodlight should be fixed to a stable outdoor wall made of a non-flammable
material approximately between 0.5-3.0 m above the ground and at an angle of
± 60°, preferably in a location under eaves where the unit is protected from the
elements and shielded from direct sunlight.
•
Do not block the front of the detection window and make sure the detection area
holds no moving objects.
•
Do not install the device close to air conditioning vents, radiators, etc.
Mounting the Lamp
1.
This luminaire does not have a built-in device to disconnect it from the electric
mains. Make sure to electrically isolate the luminaire before installation or
maintenance activities are performed.
2.
Use the mounting bracket to determine the location of the mounting holes.
3.
Drill the holes and secure the bracket using screws and wall plugs.
4.
Connect the power cable to the screw terminal. Make sure there is no strain on the
cable; leave sufficient slack.
V. 04 – 08/12/2021
LEDA500xxW-x/LEDA5010NW-B
4
©Velleman Group nv
Publicité
Table des Matières
