skilsaw SPT5007-EA Mode D'emploi page 11

ATTACHING THE 1-1/2 INCH DEPTH
1. Set the saw on its side on a flat surface with
the blade guard facing up .
2. Loosen the depth adjustment lever, then ad-
just the cutting depth so that the depth stop
can be inserted into the slot of the calibrated
depth bracket .
3 . Insert the depth stop and ensure that the
depth stop rests flush against the bottom end
of the slot in the calibrated depth bracket
(Fig . 9a) .
4 . Attach the hex nut to the depth stop, and use
the wrench, provided with the saw, to tighten
it (Fig . 9b) .
5 . Lower the saw assembly as far as the depth
stop allows and tighten the depth adjustment
lever to lock the saw at this depth.
STOP
Assembly
FIG. 9a
Calibrated
depth bracket
FIG. 9b
-11-
Depth
adjustment lever
Depth stop
Wrench
Hex nut