emerio TFN-214473.1 Mode D'emploi page 7

1. Before use, hold the fan body with one hand and the other hand to set the wind outlet 15° before and after.
2. Connect the adapter into the power connection of the fan first and then insert the adpater into a suitable
power outlet. The digital display lights up and the fan goes into standby mode.
3. To switch on and off:
Press the touch screen button (the digital display) the buzzer will beep once and the fan will start. Press and
hold the touch screen button for 2 seconds the buzzer will beep twice and the fan will stop running after you
release your hand.
4. To set the air volume:
When the fan is operating press the touch screen button to adjust the air volume from 1 to 9.
5. To set the oscillation function:
When the fan is operating press and hold the touch screen button for 1 second. The buzzer will beep once
and the fan will start oscillating. Press and hold the touch screen button for 1 second again. The buzzer will
beep once and the fan will stop oscillating.
Note: This appliance is equipped with the negative ions function. Once the appliance starts working, the
negative ions function is activated automatically, emitting negative ions to purify the indoor air. The indicator
" " will show on the digital display.
To use the remote control:
Press the power button to turn on/off the appliance.
Press the mode button to choose your desired wind speed:
sleep mode / fresh mode / boost mode: the digital display will
show "L" / "-" / "H" and the wind speed will become minimum
/ adjust among speed 3-4-5 / become maximum. You can exit
the mode by pressing the button "+/-".
Press the UV sterilization button to turn on the UV sterilization
function. The UV indicator will be on. The UV lamp inside the
appliance will effectively kill bacteria/virus in the air. Press the
button again to turn the function off. This function will
automatically shut down after 1 hour.
Press the oscillation button to turn on the oscillation function.
Press this button again to stop oscillating.
Press the "+" button to increase the air volume. Press the "-"
button to decrease the air volume. There are 9-speed settings.
Press the timer button to set the working time from 1 to 8
hours. A small "·" will flash on the digital display to indicate the
timer is under setting/operation.
Note:
1. The digital display will extinguish in approx. 20 seconds with no operations. If you want to do further
operations, firstly press any button (except for the power button) on the remote control or press the touch
screen button on the fan body to turn on the digital display and then press your desired buttons to choose
your desired functions.
2. After the timer is set, the digital display will turn back to show the speed level and extinguish later. If you
want to check the remaining time, turn on the digital display first and then press the timer button once on
the remote control, the remaining time (by hour) will be shown on the digital display.
- 6 -