Christopeit Sport EM 40 Mode D'emploi page 16

Assembly instructions
Remove all the separate parts from the packaging, lay them on the
fl oor and check that all are there on the basis of the packing list in
these instructions for assembly and use. Please note that a number
of parts have been connected directly to the main frame and preas-
sembled. In addition, there are several other individual parts that have
been attached to separate units. This will make it easier and quicker
for you to assemble the equipment.
Step 1:
Attach the stabilizer (36) + (59) at main frame (31).
1. Attach the front foot (59) with the preassembled transport rollers (58)
to the main frame. Do this with the two screws (37), washers (33), spring
washers (65) and cap nuts (32).
2. Attach the rear foot (36) to the main frame. Do this with the two screws
(37), washers (33), spring washers (65) and cap nuts (32). After assembly
has been completed, you can compensate for minor irregularities in the
fl oor by turning the wheel at cap (35). The equipment should be set up that
the equipment does not move of its own accord during a training session.
Step 2:
Attach the pedals (23L+23R) at pedal crank (25L+25R).
1. Screw the right pedal (23R) into the locator in the right-hand side (as
seen in operation) for the pedal crank (25R) (warning! the screw direction
is clockwise).
2. Screw the left pedal (23L) into the locator in the left-hand side (as seen
in operation) for the pedal crank (25L)
(Warning! the screw direction is anti-clockwise).
3. Then mount the pedal straps left and right on the associated pedals (23).
(The pedals are signed with „L" for Left and „R" for Right.)
Step 3:
Attach the front post (64) at main frame (31).
1. Slide the handlebar support cover (61) onto the handlebar support (64).
2. Hold the handlebar support (64) with the computer cable (62) against
the main frame holder. Connect the plug for the computer cable (62) co-
ming out of the bottom of the handlebar support (64) of the computer with
the matching plug for the sensor cable (60) coming out of the main frame
(31).
(Note: The computer cable harness (62) projecting from the support (64)
must not slide into the tube, as it is required for later steps of installation.)
3. Place the handlebar support (64) in the locator provided for it in the
main frame (31). Ensure that the cable connection made in step 3 are not
squashed. When putting the steering tube in place, push the former slowly
down into the locator in the main frame. Screw the handlebar support (64)
onto the base frame (31) with the screws (63), spring washers (65) and
washers (33).
16