mdp FIRST Mode D'emploi page 22

OPERATING INSTRUCTIONS
FIRST-rev 01
MODE
Absorption
Equalisation
End of
Equalisation
Floating
Internal
Temperature
fault
Output
voltage fault
Battery
fuse fault
"Night" Mode
12V-25A
12V-40A
24V-20A
(1)
(2)
(3)
(4)
(5)
(6)
(7)
LED STATUS
The batteries are charging. Time
Steady
required to complete Absorption
yellow
mode varies depending on the
(1)
initial status of the batteries, but is
limited to 6 hours.
The batteries are coming to the end of
Yellow the charging cycle. Time required to
complete Equalization mode, depen-
blinking
ding on the initial status of the batteries,
(2)
varies from 30 minutes to 4 hours.
The batteries are almost charged.
Green
Floating mode will begin in less
blinking
than 30 minutes.
(3)
The batteries are completely charged.
Green (4)
The charger is on Standby for a
Red
period of between 30 seconds
fixed
and 10 minutes. Once the fault has
(5)
been solved, the device will start
up again automatically.
If this problem arises, please
4
check the external temperature
as well as the internal fan and the
space around the charger.
The charger is on Standby for a pe-
riod of 30 seconds. Once the fault
Red
has been solved, the device will
blinking
start up again automatically.
(6)
In reality, the PC Board has pro-
4
bably failed and the damage is
irreversible.
The fuse should be replaced.
Red
Please check all connections as
4
Flashing
well as the battery's polarity and
(7)
status
This mode allows the charger to
work without noise (from the fan).
In this case, charging levels adapt.
-
To activate this mode, press the
button for about 2 seconds. To
deactivate, a simple press of the
button or the mode deactivates
automatically after 10 hours.