mdp FIRST Mode D'emploi page 16

WARNING
FIRST-rev 01
BEFORE OPERATION
THIS MANUAL CONTAINS VITAL AND ESSEN-
TIAL INFORMATION. IN ORDER TO AVOID
ELECTRICAL SHOCKS OR OTHER DAMAGE,
THE OWNER SHOULD READ AND UNDERS-
TAND THIS IMPORTANT DOCUMENT BEFORE
OPERATING THE CHARGER.
Contact mdp electronics if you do not unders-
tand a statement.
This device is not intended for use by persons (in-
cluding children) with physical, sensory or men-
tal disability, or by persons lacking experience
or knowledge, unless they have received from a
person in charge of their safety adequate super-
vision or preliminary instructions on how to use the
device.
Before Installation.
4In order to avoid overcharging or irreversible
damage to the materials, please follow closely
all recommendations cited below. Do not install
this system near inflammable materials. An owner
should seek guidance from an authorized DOL-
PHIN dealer or the factory.
4Do not install this device near a heat source.
4It should not be installed in an airtight or badly
ventilated area.
4All ventilation ducts must be unobstructed.
4Leave at least 10 cms / three inches clearance
around the device for proper ventilation.
4Mount in a vertical position, to create natural
ventilation for the charger. Note that the wiring
connections are at the bottom of the charger.
4All electrical connections to and from the
charger must remain accessible at all times.