mdp FIRST Mode D'emploi page 17

UK
FIRST-rev 01
4This system should not be exposed to water or
dust.
4It is strictly forbidden to tamper with the system
casing in any way.
4This device is not a toy and must be kept out of
the reach of children.
Connecting the Device.
In order to avoid all risk of electric shock or irrever-
sible damage to the device, please follow very
carefully the following recommendations
4This device is set to be connected to a mono-
phase network 230V 50Hz or 115V 60Hz (except
10A & 15A)
4The installation to which the device is connec-
ted must comply with the standards currently en-
forced in the country of use.
4In order to protect the occupants, the input
point must be attached to a differential circuit
breaker. Please refer to the specific characteris-
tics of the circuit breaker.
4For security reasons, the system's PE terminal
must strictly be connected to the installation's
Earth (green/yellow wire in the cable section).
Please consult the wiring diagram.
4To prevent overheating, ensure the correct
connection and size of cables.
4The input cable must not exceed 3 meters (10
feet) and the output cable 1.5 meters (5 feet).
4All cable connections and connectors must
be maintained in good condition. Once the
connection of the AC cable has been comple-
ted it is imperative to fit the Winsta Wago snap
on security cover. See "Assembling the Shore
Power Connector"