To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna K1 PACE Manuel D'utilisation

4. Push and hold the On/Off button until the green LED
light comes on.
5. Push the power trigger to start the motor.

To stop the product

1. Release the power trigger.
2. Push and hold the On/Off button on the control panel
until the green LED light goes off.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
WARNING:
correctly can decrease the product life

Maintenance

Clean the external parts of the product.
26
Maintenance
Read and understand the
Remove the battery before
Failure to do maintenance
3. Push the battery release button and remove the
battery from the battery holder.
WARNING:
you do not use or when you do not have
full vision of the product. This is to prevent
accidental start.
cycle and increase the risk of accidents.
All servicing and/or repair work must also
be done by a professional. Turn to your
servicing dealer for more information.

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product.
Remove the battery when
Before
Weekly Monthly
use
X
1598 - 002 - 14.02.2022