Tilt Protection; Operation - Priorit PRIODOC AS32 Série Mode D'emploi

Tilt Protection

Attach the enclosed angle bracket to the upper part of the cabinet using the 4 x 4.5 x 35 screws and attach
the cabinet to a suitable wall using any suitable enclosed dowel.

Operation

Doors
The catch must engage the strike plate on the middle shelf to close the doors.
The bolts inside the lock do not have a function.
The doors can be removed by removing the hinge pins.
Shelves
The shelf height can be changed by moving the shelf supports on the 32 mm grid. Make sure all shelf
supports (4 with centre partition, otherwise 5) are inserted in the pre-drilled holes at the same height.
The shelves can support an evenly distributed load of 75 kg.
Suspension File Pull-outs
Make sure only one suspension file pull-out is open at a time. To close, push it back in all the way to the end
stop to prevent blocking the doors and damaging the pull-outs.
A cabinet with suspension file pull-outs must be attached to a suitable wall to prevent
tipping over.
EP.V.9906-3
dowel
4.5 x 35 mm
4,5 x 35 mm
21 von 88