TV Control Buttons & Operation
1. Standby On/Off button
2. TV/AV button
3. Programme Up/Down buttons
4. Volume Up/Down buttons
Operation with the Buttons on the TV
Press
button to decrease the volume or
button to increase the volume, so a volume
level scale (slider) will be displayed on the
screen. Press P/CH + button to select the
next programme or P/CH - button to select
the previous programme.
Press the
or
same time to view the main menu. In the
Main menu select a sub-menu using TV/AV
button and set the sub-menu using
or
buttons. To see what options are
available via the menu, refer to the menu
system section of this manual. Press the TV/AV button
in the control panel on the TV to switch between AV
modes.
Note: Function indications of the buttons will be
displayed on the screen when pressed.
Inserting the Batteries into the Remote
Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct polarity)
Replace the cover.
button at the
English - 27 -
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable/Satellite Connection
Connect the aerial or cable TV plug to AERIAL INPUT
(ANT-TV) or satellite lead to LNB INPUT(ANT SAT)
socket located on the rear bottom side of the TV.
Rear bottom side of the TV:
Notiication
Manufactured under license from Dolby Laboratories.
TRADEMARK ACKNOWLEDGMENT
"Dolby" and the double-D symbol are trademarks of
Dolby Laboratories.
"HDMI, the HDMI logo and High-Deinition Multimedia
Interface are trademarks or registered trademarks of
HDMI Licensing LLC."
"DLNA, the DLNA Logo and DLNA CERTIFIED are
trademarks, service marks, or certiication marks of
the Digital Living Network Alliance."
"YouTube and the YouTube logo are trademarks of
Google Inc."
Aerial or Cable