dirna Bergstrom Bycool COMPACT1.4 Instructions De Montage page 22

COMPACT 1.4
EN
Position the interior air distribution panel
11
on the front studs with (1) M6 wide-flanged
washer and (1) M6 nut on each stud. Tighten
the nuts until the interior air distribution
panel duct comes up against the unit's top
foam.
Important: The interior air distribution
panel duct must come up against the
unit's upper foam in order to prevent any
leakages of air.
Take care to ensure the cables do not
become trapped between the duct and the
foam in the base of the unit.
11
EPDM
Gasket
Cabin roof
Upholstey
Tighten the nut in point 10a until it comes
12
up against the top part of the interior air
distribution panel.
12
EPDM
Gasket
Cabin roof
Upholstey
Unit base
M6 Nut
M6 stud
Base Compact
M6 Nut (10a)
M6 Nut
M6 stud
Interior air distribution panel
Interior air distribution panel
22
Foam
Foam
®