Installation Location; Electrical Connection - Electrolux ERN19510 Notice D'utilisation

INSTALLATION
Location
The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
For building into kitchen units follow
the special " Building-in" instructions
given.
Attention
It must be possible to disconnect the
appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.

Electrical connection

Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must
be used.
The a a ppliance m m ust b b e e e arthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to
a separate earth in compliance with
current regulations, consulting a
specialist technician.
The M M anufacturer d d eclines a a ll
responsibility i i f t t he a a bove s s afety
precautions a a re n n ot o o bserved.
This appliance complies with
the following E.E.C. Directives:
• 87/308 E E EC of 2/6/87 relative to
radio interference suppression.
• 73/23 E E EC of 19.2.73 (Low Voltage
Directive) and subsequent
modifications;
• 89/336 E E EC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent
modifications.
electrolux 49