Cartrend 10737 Mode D'emploi D'origine page 32

Checking the tyre pressure
• The tyre pressure increases as the temperature rises.
The recommended tyre pressure is typically speci-
fied for cold tyres (approx. 20 °C). Please refer to the
owner's manual for your vehicle.
• Do not check the tyre pressure on warm tyres (e.g. after
long trips).
1. No valve adapter required to inflate car tyres. First
remove the cap from the tyre valve.
2. Press the locking lever [15] to release the chuck [16].
3. Attach the chuck [16] to the vehicle's valve and release
the locking lever [15].
If the chuck [16] is correctly connected to the vehicle's
valve, the pressure gauge [8] will show the current tyre
pressure.
4. If this value corresponds to the recommended tyre
pressure for the vehicle you can remove the valve
adapter [16].
Inflating the tyre
Attention!
Do not operate the compressor for more than 6 minutes.
After this time allow the unit to cool down for 10 minutes!
If the value shown is below the vehicle's recommended
tyre pressure, proceed as follows to adjust it:
5. Squeeze the trigger [10] on the blow gun [11].
6. Once the pressure gauge [8] shows the recommended
pressure, release the trigger [10].
7. Carefully remove the chuck [16].
32 Case compressor