Cartrend 10737 Mode D'emploi D'origine page 31

Connecting/disconnecting valves adapters
1. Connect the air hose [14] to the blow gun [11].
2. Select the respective nozzle.
3. Press the locking lever [15] to release the chuck [16].
4. Needle/nozzle [17-19]:
Insert the nozzle in the chuck [16].
Nozzles [21]:
Insert the valve adapter [20] in the chuck [16]. Attach
the respective nozzle [21] to the valve adapter.
5. Release the locking lever [15].
6. Verify the valve adapter is tight.
Observe the maximum pressure of the item you wish to
inflate and read the respective operating instructions.
Switching the compressor on/off
Attention!
Always wear suitable hearing protection and
suitable safety glasses when using this product.
1. Connect the blow gun and the desired valve adapter.
2. Connect the power plug [4] to a 230 V mains socket.
3. Set the On/Off switch [1] to "I" to switch on the com-
pressor. The compressor stars and build the required
pressure.
Note:
The compressor can be switched off at any time by
switching the On/Off switch [1] to the "0" position.
4. Perform the desired tasks as described in the following
chapters.
5. Set the On/Off switch [1] to "0" to switch off the com-
pressor.
6. Disconnect the power plug [4] from the 230 V mains
socket.
EN Original instruction manual 31