Before Starting The Equipment; Setting The Cutting Heights - Nakayama 310.200.650 Traduction De La Notice D'emploi Originale

Vibration at the handlebars a
Protection class:
The declared value of the vibrations was
measured by a standard test method that can
be used for comparison tool with another. It can
also be used as part of a preliminary assessment
of the degree of exposure.
WARNING! The value of the actual vibrations
emitted while using the device may be different
from the declared value depending on how
the tool is used. Estimate the exposure in the
real conditions in order to identify the security
measures taken with regard to personal
protective equipment (taking into account all
parts of the business cycle: times when the tool
is off, when he is asleep, he is on).
The level of loudness perceived by the user may
exceed 85 dB(A), necessitating the use of ear
muffs.
Keep the noise emissions and vibrations to a
minimum.
• Only use appliances which are in perfect
working order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever
necessary.
• Switch the appliance off when it is not in use.
• Wear protective gloves.

6. Before starting the equipment

The lawn mower is delivered unassembled. The
complete push bar and the grass collector must
be assembled before using the lawn mower.
Follow the operating instructions step-by-step
and use the pictures provided as a visual guide
to easily assemble the machine.
:
hv
2 2
2,4 m/s , k=1,5 m/s
II/
6.1 Fitting the push bar (Fig. B3 to B6)
Fit a bottom push bar (Fig. B3 / Item 8) into the
opening provided for it (Fig. B3) and secure it as
shown in Fig. B4 with a screw (Fig. B4 / Item 9).
Proceed in the same way on the other side.
When you fit the top push bar you can decide
the height of the push bar by selecting the
appropriate fastening hole (Fig. B5). Fasten the
top push bar using the holes. Screw the top
push bar to the bottom push bar as shown in
Fig. B6.
6.2 Fitting the grass box (Fig. B7 to B10)
Fit the two halves of the grass box together (Fig.
B7 / Item 12). Ensure that all the clips engage
correctly (Fig. B8). Before you fit the grass bag
you must ensure that the motor is switched off
and the blade is not rotating. The grass box must
be attached to the two hooks on the mower (Fig.
B9 / Item A). To do this, open the ejector flap
with one hand (Fig. B10 / Item 5) and attach the
grass box with the other hand as shown in Fig.
B10. The ejector flap is held against the grass
box by a spring.

6.3 Setting the cutting heights

Important!
Adjust the cutting height only when the engine
is switched off and the power cable has been
disconnected.
Before you begin to mow, check to ensure
that the blade is not blunt and that none of
the fasteners are damaged. To prevent any
imbalance, replace blunt and/or damaged
blades. To carry out this check, first switch off
the motor and pull out the power plug.
The cutting height is adjusted as shown in Figs.
B11 and B12. To do this turn the hub cap to
release the axle (Fig. B11) and remove the hub
cap with the screw and tire. The tires can now
be fitted in position 1, 2 or 3 to suit the required
cutting height. Fit all four tires at the same
height so that the cutting blade runs parallel to
the lawn.
17