Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Blade - Nakayama 310.200.650 Traduction De La Notice D'emploi Originale

cm of grass length in any one pass.
Switch off the motor before you carry out any
inspections of the blade. Remember than the
blade will continue to turn for a few seconds
after the motor has been switched off. Never
attempt to stop the blade.
Check regularly that the blade is correctly
secured, in good condition and well ground. If
not, grind or replace the blade. If the moving
blade strikes an object, stop the mower and
wait until the blade has come to a complete
standstill. Then check the condition of the blade
and the blade holder. If they are damaged, they
must be replaced.
Place the mains lead in loops on the ground in
front of the socket. Mow away from the socket
and cable and ensure that the mains lead is
always on the section of lawn that you have
already mowed so that you do not run over the
mains lead with the mower.
As soon as you see mown grass on the lawn
whilst you are mowing, the grass bag will need
emptying.
Important!
Before you remove the grass bag switch off the
motor and wait until the cutting tool reaches a
standstill.
To remove the grass bag, raise the discharge
flap with one hand and remove the grass bag
using its handle with your other hand.
To maintain safety, the discharge flap will close
when you remove the grass back to seal the
rear discharge opening. If any grass residues are
caught in the opening, it is a good idea to pull
the mower backwards around 1 m to make it
easier to start the motor.
Do not remove grass cuttings in the mower
casing or on the cutter by hand or with your
feet. Instead use suitable tools such as a brush
or broom.
To ensure that it can collect the grass correctly
the grass bag and in particular the net must be
cleaned from the inside after use.
Only attach the grass bag after switching off
the motor and the cutting tool has reached a
standstill.
Raise the discharge flap with one hand and,
holding the grass bag by its handle in your
other hand, attach it from the top.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before
starting any cleaning work.
8.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
• We recommend that you clean the device
immediately each time you have finished using
it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water
can seep into the device.

8.2 Replacing the blade

For safety reasons, we recommend having the
blade replaced by an authorized professional.
Important.
Wear work gloves!
Carry out the following steps to change the
blade:
• Undo the fastening screw (Fig. B15).
• Remove the blade and replace with a new one.
• When fitting the blade, make sure it is installed
in the right direction. The blade's air vanes must
jut into the motor compartment.
• Then retighten the fastening screw. The
tightening torque should be approx. 25 Nm.
19