Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Introduction
Names and Operations of Parts (continued)
Body Underside
3
4
1
Power Supply cable
To input DC 12 V or AC 24 V power.
The AC 24 V power supply should
conform to the following:
U-type: Class 2 only
E-type: Isolated power supply only
Video signal output connector (BNC)
2
This BNC connector outputs a composite
video signal. Connect this to the video
input connector of a video monitor,
switcher, etc.
3
Safety cable
This wire is mounted to the ceiling slab
or channel. (Safety cable not included.)
CAUTION:
To avoid unforeseen accidents, attach the
safety cable. Otherwise, there is nothing
to prevent the camera from falling should
it come loose.
E-8
2
1
7
6
7
4
5
6
7
4
Main unit side
5
Mounting holes
These holes are used to mount the
camera body to the ceiling. When using
a 4 inch square electrical box, the 2 holes
diagonally across are used to fix the box
in place.
(
page 13)
Cable extraction hole
This hole is used to extract cables from
the side of the camera without opening
holes in the ceiling.
Cover
This cover is removed to pull the cables
through the
cable extraction hole.
5
Replace the cover after pulling the
cables.
Cover locking screw
This screw is removed when removing
the
cover.
6
Publicité
Chapitres
Table des Matières
