Master Section - Peavey RQ 200 Guide D'utilisation

28
29
25
24
23
22
21
26
27
Plugging into the 1/4" headphone output disconnects the 3.5mm head-
phone output. In applications where the RQ
based recording, this jack makes an ideal input to powered speakers.
Application note #10 on page 8 describes this process in more detail.

MASTER SECTION

21. Master Left/Right Fader: Master L/R level control. Since the main sig-
nal comes from this mix, all main outputs (16) will be affected by its adjust-
ment. The output levels are monitored by the left and right meters. The
optimum setting for this control is the Ò0Ó (unity gain) position.
22. Headphone Level: Adjusts the level of the headphone outputs.
23. Effects Master: Controls the level of the Effects signal found at the
Effects Send jack.
24. Monitor Master: Controls the overall level of the Monitor mix found at
the Monitor Send jack.
25. LED Meters: Two 5-segment LED arrays monitor the levels of the
main L/R outputs. The 0 dB reference level corresponds to +0 dBu at the
1/4" jacks. The Clip LED at the top of each array illuminates when the
signal is either clipping or is within 2 dB of clipping.
POWER
26. AC Input: The external 16.5 volt, 1 amp power supply should be
plugged in at this jack. Plug the small barrel connector of the supply
into the RQ ª 200 and plug the power supply into a main AC power
receptacle which provides the proper line voltage as indicated on the power
supply casing.
27. Power: The mixerÕs main power switch. Pressing the switch in will
provide power to the RQ
unit is powered.
28. Power LED: Illuminates to indicate that the RQ
29. Phantom Power: Applies 22 VDC voltage to the input XLR
connectors to power microphones that require it. If phantom power is used,
do not connect unbalanced dynamic microphones or other devices to the
XLR inputs that cannot handle this voltage. (Some wireless receivers
may be damaged; consult their manuals.) The line input jacks are not
connected to the 22 V supply, and are safe for all inputs (balanced or
unbalanced).
NOTE: When the RQ
the Phantom Power is 8 VDC. However, additional battery positions
are provided in the battery compartment so extra cells may be added to
provide 17 VDC. See Battery Compartment #30 for more information.
ª
ª 200. The Power LED indicator will light when the
ª 200 is being powered by battery,
6
200 is used for computer-
ª 200 is powered up.