General Operation - ION FREESOUND Guide D'utilisation Rapide

GENERAL OPERATION

1. Select a proper iPod docking adapter (enclosed with
the purchase of an iPod) and place it into the
FREESOUND base. Then dock your iPod gently.
2. Switch on the speakers and begin to play your
iPod. This needs to be done before step 3 in
order for the speakers to sync with the dock.
3. Plug the included power adapter plug into power jack
at the rear side of the FREESOUND base. The unit
should then automatically power on. Alternatively,
use the remote control to power on the unit.
4. Press "VOL +" or "VOL –" to choose a proper volume
level. Take the speakers from room to room to test
(Subject to its surroundings,
approximately 100 feet in an open area without any
interference).
5. If using an iPod shuffle or another audio source with
a 3.5 mm headphone output, connect it to the AUX
line in jack on the rear of base. The transmitter LED
indicator will turn red when the Aux input is being
used. The LED indicator will turn red when an iPod is
docked and transmitting a signal.
Note: The AUX In will not work when an iPod is
docked.
CHARGING INDICATORS
• While the speaker is being charged and the volume rotary knob is not turned on, the speaker LED indicator will be
solid red. Once fully charged, the LED will turn solid blue.
• When the speaker is charging and the volume rotary knob is turned on, the speaker LED indicator will flash purple.
Once the unit has been fully charged, the LED will turn solid blue.
• When the speaker is separated from the FREESOUND dock and the volume rotary knob is being used, the LED
indicator will be solid blue. If the LED is blank, the volume rotary knob will not produce any output of sound,
indicating there is no more battery power.
• When connecting a device to the Aux-in, once the LED indicator turns red, the device can be used. When
connecting an iPod/iPhone to the FREESOUND, once the LED indicator turns blue, the iPod/iPhone can be used.
OUTPUTTING VIDEO FROM AN iPod/iPhone
1. Connect FREESOUND to a television or other video display that has a composite video input.
2. Securely dock your iPhone or iPod with video capability.
3. Connect one end of an RCA cable (not included) to the rear RCA video jack on the FREESOUND base.
4. Connect the other end of the RCA cable to the VIDEO IN of a television or video display.
5. Select a movie from your iPod/iPhone menu.
6. Make sure the iPod's TV Out menu is set to "ON".
7. Switch back to the movie library and play the movie of your choice.
Note: Video will automatically output when using an iPod touch or iPhone.
the range is
5